It is great fun to work with PixelCNC. I am currently working on a photo conversion to 3D. That works well but I have a question. In the simulation of PixelCNC I see that the bit neatly finishes the canvas row by row without interruptions during 3D parallel carving. I use the G-code in Candle and there I see that the bit is very often brought to the safe height and then continues. That takes a lot of time. Why this difference between the simulation and the execution (in Candle) and can this be prevented. I hope I explained it well. I can of course add the G-code if desired. Best regards, Nico