Hi AKEric, here's what I've done so far with the tool library. I was hoping you could provide some further feedback on it, if you have any ideas or suggestions:
So now there's four buttons at the top to sort the tool definitions by different means, their slot #/index, their cutter type, diameter, and flute length. The diameter is a bit tricky because a tapered endmill is defined by the diameter of its tip and the flute length and taper angle are used to calculate its diameter from there. Also it's not currently differentiating between inches/metric when sorting by physical dimensions. A 6mm diameter cutter is "bigger" than a 0.5" diameter cutter purely because it's going off numeric value. It's all fixable, I just thought I'd show you what I've done on it so far.
Let me know what you think :)
Charlie