Hi Rustrust thank you for replying to my post trying to calibrate my dx6i to FPV Freerider as soon as i deviate from pressing OK the controls go all over the place , going through the set procedure pressing OK after each move all works except YAW . Yaw is first control to set but when you move the stick it only moves in one partly direction up no movement down and it does not highlight YAW as of the other three controls Thr -Roll-Pitch which have full movement up /down and are Highlighted as you select them it is as Yaw control can't be seen ??? i am wondering weather FPV Freerider firmware has downloaded properly or am i doing something wromg Kind Regards Weebydand
As you are calibrating yaw - click the little circle that you see is corresponding to the yaw stick, while holding the stick in the position shown on screen.
The circle should then should then highlight, saying "yaw".
When calibrating the other sticks, you can just press OK as usual.
(It shouldn't actually matter whether you click the little circle, or click OK, just as long as you are holding the stick fully in the direction shown on screen).
If the yaw movement is still not correct when you come to the trim settings screen you can adjust it using the sliders.
I'm sure it's not a problem with the download. Make sure you don't have any other controllers/gamepads/drawing tablets connected at the same time as that might cause a conflict.
Hi I have done exactly how you said it is the only time "yaw" appears in green but when i go to check screen all other controls work fine Thr-Elev- Pitch but yaw stick moves from centre bearly 3mm to left and nothing to right exactly same movement as on centre sticks page on line of small circle as i try each control on the little circles Thro -Elev-Pitch all move same amount up and down 4mm but Yaw circle bearly moves up 1mm and no movement down their is something a mis how do you reach FPV FreeRider after sales service please kind regards Weebydand
Please check that you are using a standard model setup on your radio.
(That is, that the endpoints are the same for yaw as for the other channels)
Also, perhaps it will work better if you remap the yaw stick to another channel (in the settings of your radio) .
From what you are describing, it sounds like there's a chance you could get it working by adjusting sliders on the trim settings screen in Freerider.
Try to pull the scale slider (for the yaw channel) until you get more movement.
After that you can use the trim slider to get the center position correct.
You can email fpvfreerider@gmail.com for further support.
(Perhaps you can make a short video that shows what happens when you go through the calibration).
Dear Sir I have re-calibrated all controls end points are the same you can not remap Dx6i all scale trims do is get large circle from Right stick to left stick I have even tried Dx5e and it behaves exactly the same it is as through I am using same transmitter the fault is with the Download fpv freerider I am in dispair kind regards weebydand
Great, glad to hear that you managed to get it working by using the smartpropoplus method!
You can also find more general information in the user manual.