Hi these look great. Could you elaborate on the pre cut ender sized printer files. Assuming you mean the ender 3 with a build plate of 220x220x250mm just wanted to confirm before buying if it will actually fit on my bambu lab a1 (256x256x256mm) incase you ment a different ender. And I assume its age to say that all the designs have the pre cut files. Thanks so much
Viewing post in Canine Fursuit Bases comments
the cut version is sized for ender 3 so 220x220x250
BUT the bambu can handle the un-cut versions for most of these because its a little bigger than an ender (and most of these are 240-250mm wide when printed at a wearable size)
You'll want to add a little bit of manual support around the bottom inch or so of the print, though, just to keep it from falling over- bambu slicer doesn't make very good rafts so it can have bed adhesion issues with tall/thin prints like headbases or masks