Hi again. OK, I downloaded the Windows version to start figuring it out. Is there a forum somewhere to ask questions? or is there a section on the Apollo discord? I couldn't see how to save programs. Probably something simple, but I couldn't see how. Also, I couldn't figure out how to get the examples from the example.html page in to see what they look like -- I assumed I could cut and paste, but that only worked one line at a time, which didn't seem correct. Anyway - where us there a user community forum for help/instructions. Thanx.
Hi Todd,
to save you press Control + S, to run Control +R. I dont have a windows device to throughly test on just my sons laptop (which I rarely get access to) if you run into any issues with the saving etc let me know and i can wrench the laptop form him and check.
The examples you would have to type in but they are quite small. I tested them so they definately work
I can set up a discussion forum in this itch.
With the copy paste of the examples into Fred80 - ive been considering that. I can try to implement that this weekend and send it to you if that makes things easier while you experiment with fred80.
OK - I wouldn't be surprised if Apollo would give an area on their discord. They have a thread for #ApolloBoot (which I don't think is an official internal project? Maybe? May be Not?🤷) and so them maybe adding a thread for #Fred80 would be a nice, convenient place too? It feels like a #Fred80 thread on the Apollo Discord would be seen by EVERYONE with an Apollo accelerator (and those considering an Apollo accelerator/board)
And yes, I would think that Cut & Paste would be very valuable, vs typing with my old eyes. 😁
I do also have a few suggestions - but I probably should try to find a manual... CRTL-S and CTRL-R are probably already documented somewhere which I didn't see yet. :)