Process Overview

This is my reference for Model 1 -- the Incense Burner, This photograph was taken during my previous trip.

This is my model blocking.

This is my finished model. I added the railings, curved roof sections, decorative structures, and the supporting legs. 

I have UVED the model as well. I chose to use two UVs because decorations are much smaller than the main sections.

I used the Substance Painter's smart materials function to make my model's texture.

This is my Wireframe Turntable Render.

This is my Model 2's reference, this reference is not my own creation, I collected it from artist : ArtStation at the pinterest.

I finished the main shape of the radio model.

I completed the modeling of the radio. All major shapes and details are now in place.

After that, I unwrapped UV of the model as well. I tried to create clean UV islands, avoiding stretching.

And then, I painted the base colors, metallic values, surface details and so on for the radio model.

This is my Shaded and Textured Model 2 -- the Radio's turntable render.

This is my Wireframe Turntable Render.

This is the reference of my Model 3, this reference is not my own creation, I collected it from artist : Little Demian at the pinterest.

This is the start of my machine model. In fact, it could be considered as middle-finished state, because I had already spent about three hours on it before.

I completed the base section of the model, make it ready to uv.

I uved the model properly and try to create clear uv islands for texturing.

In this stage, I completed the texturing and material processes of the model using Substance Painter. And there are some problems in my Previous UV, so I have to rewrap some sections' UV.

This is my Shaded and Textured Model 3 -- the Machine's turntable render.

This is my Wireframe Turntable Render.

Thanks for reading my Blog and the overview of my modelling process.